Featured
New Product
Futaba 4FYG-R8004GF
The new 4YF 2.4GHz radio system makes Futaba quality FHSS (Frequency Hopping Spread Spectrum) tec..
Rp 1,615,000.00
LED CORN LIGTH 12V 1.8W
2 pcs ..
Rp 70,000.00
Best Sellers
Delta-8 FrSky 8ch 2.4GHz
8ch 2.4GHz FrSky D8/V8, Futaba FHSS/S-FHSS and Hitec A-FHSS Receiver with CPPM/RSSI Output Mode ..
Rp 450,000.00
CORONA 4CH 2.4 GHz DSSS
Corona 4 Channel 2.4Ghz DSSS Receiver. Can only be used with Version II Futaba &..
Rp 280,000.00
COVERING FILM WHITE
1 meter ..
Rp 80,000.00

AFRO ESC 12A ULTRA LITE

Product Code: AFRO12AUL
Reward Points: 0
Availability:
In Stock
Price: Rp 230,000.00

 

Developed from the ground up, we wanted to build a truly Multi-rotor specific ESC that would offer the best performance and value in the market today. We wiped the slate clean and looked to the community for inspiration and help in designing an ESC that truly could be known as “The Multi-rotor ESC”

Enter Simon and Hamasaki AKA SimonK and timecop. This combination of hardware and firmware expertise in conjunction with the Hobbyking in house engineering team gave us the edge needed to develop an ESC like no other and hence the Afro series was born. 

Boasting high efficiency, all N-channel MOSFET design, jitter-free hardware PWM input, and smooth power response the Afro ESC series are set to change the expectations of multi-rotor pilots around the globe. The Afro ESC series ship with multi-rotor specific SimonK software preloaded! No need to reflash. For added convenience the Turnigy USB linker can be used via the PWM signal lead for any future software updates eliminating the need for complicated flashing jigs or the need to cut open the heat shrink.

MikroKopter I2C compatibility has also been built in as standard. A DIY port is available under the shrink wrap which allows using the ESC with MikroKopter hardware that uses I2C control.

Specs:
Current Draw: 12A Continuous
Voltage Range: 2-4s Lipoly
BEC: 0.5A Linear 5.0v
Input Freq: 1KHz
Firmware: afro_nfet.hex
Discharge wire/plugs: 20AWG/Male 2mm
Motor wire/plugs: 20AWG/Female 2mm
Weight: 10g (Included wire, plug, heat shrink)
Size: 25 x 20 x 6mm

Write a review

Your Name:
Your Review: Note: HTML is not translated! Rating: Bad            Good
Enter the code in the box below: