Featured
New Product
Futaba 4FYG-R8004GF
The new 4YF 2.4GHz radio system makes Futaba quality FHSS (Frequency Hopping Spread Spectrum) tec..
Rp 1,615,000.00
LED CORN LIGTH 12V 1.8W
2 pcs ..
Rp 70,000.00
Best Sellers
Delta-8 FrSky 8ch 2.4GHz
8ch 2.4GHz FrSky D8/V8, Futaba FHSS/S-FHSS and Hitec A-FHSS Receiver with CPPM/RSSI Output Mode ..
Rp 450,000.00
COVERING FILM WHITE
1 meter ..
Rp 80,000.00
MOTOR FRAME SET V929 WLTOYS
SPEC Boom,Main Shaft,bearing,gear,Motor frame ..
Rp 65,000.00

RC Talon Quadcopter Turnigy (V2.0)

Brand: Turnigy
Product Code: RC Quadcopter
Reward Points: 0
Availability:
Out Of Stock
Price: Rp 950,000.00

The Turnigy Talon V2 Quadcopter frame is a crafted from high quality genuine carbon fiber offering both great looks and performance. Our engineers set out to create a Quadcopter frame without compromise, several materials were tested and rejected until they decided that only genuine carbon fiber would meet the goals we had set out to achieve. Every component was weighed and measured shaving mere grams where possible to achieve a light weight yet extremely rigid frame. We didnt allow any compromises and neither should you.

Our team took the already popular Talon frame and studied the design, based on feed back from the multi-rotor community and our own ideas we redesigned the motor mounting plates allowing for top or bottom mounting of 28 and 35 size brushless outrunner motors (see photos for reference of different mounting options). The improved clamping system alone underwent 3 redesigns until our engineers were satisfied that the perfect strength and weight saving combination had been achieved. The center frame clamping system was almost doubled in size to ensure a strong brace on each boom. We stress tested the design until a 5kg load could be held on the center plate with minimal flex from each boom. Every aspect of this frame was thoroughly examined and thought through.

All this attention to detail has resulted in the elegant simplicity that is the Talon V2, A Quad frame that we are as proud to put our name behind as you will be to own.

We also offer a full line of quality multi-rotor electronics such as multi-rotor control board, ESC, motors and more, so there is no need to compromise on your electronics setup either!

Specs:
Weight: 280g (w/out electronics)
Width: 550mm
Motor Bolt Holes: 17/20/26mm

Requires:
28-XX or 35-XX brushless outrunner motor x 4
18~25A brushless ESC x 4
Multi-rotor control board
2200~3000mAh 11.1V lipoly
TX & RX


Write a review

Your Name:
Your Review: Note: HTML is not translated! Rating: Bad            Good
Enter the code in the box below: